Disabling The Vcstack Feature; Figure 45: Show Stack Command - Allied Telesis AlliedWare Plus x530DP Series Installation Manual

Disabling the VCStack Feature

awplus> show stack
Virtual Chassis Stacking summary information
ID Pending ID
1 -
Operational Status
Stack MAC address
awplus>
The following procedure explains how to disable the VCStack feature to
use the switch as a standalone unit.
Caution
Disabling the VCStack feature requires resetting the switch. Some
network traffic can be lost if the switch is connected to a live
network.  E89
To disable the VCStack feature, perform the following procedure:
1. Start a local management session on the switch. For instructions, refer
to "Starting a Local Management Session" on page 103.
2. To display the status of the VCStack feature on the switch, at the User
Exec mode prompt, type the command SHOW STACK.
MAC address
eccd:6dd1:64a2
Figure 21. SHOW STACK Command
3. If the Operational Status of the switch is "Stacking Hardware
Disabled," the VCStack feature is already disabled on the unit. If this is
the case, go to Chapter 10, "Cabling the Networking Ports" on page
115.
However, if the Operational Status is "Standalone Unit" as shown in
Figure 21, the VCStack feature is active on the unit. (The "Standalone
Unit" status means the switch is functioning as a stack of one switch.)
You must disable the feature to use the switch as a standalone unit.
Continue with the next step.
x530DP Series Installation Guide for Standalone Switches
Priority Status
128 Ready
Standalone Unit
eccd:6dd1:64a2
Role
Active Master
105