Verifying The Stack And Assigning Priority Numbers; Figure 62: Show Stack Command - Allied Telesis x330 Series Installation Manual

Verifying the Stack and Assigning Priority Numbers

awplus> show stack
Virtual Chassis Stacking summary information
ID Pending ID
1 -
2 -
3 -
4 -
Operational Status
Stack MAC address
awplus(config)#
To verify the stack and assign priority numbers, perform the following
procedure:
1. Start a local management session on any switch in the stack. For
instructions, refer to "Starting a Local Management Session" on
page 102.
2. From the User Exec mode, enter the SHOW STACK command:
awplus> show stack
Figure 62 is an example of a stack of four switches.
MAC address
nnnn:nnnn:nnnn
nnnn:nnnn:nnnn
nnnn:nnnn:nnnn
nnnn:nnnn:nnnn
Figure 62. SHOW STACK Command
Review the following items:
The command should list all the switches in the stack. If the list is

incomplete, refer to Chapter 11, "Troubleshooting" on page 147.
The Operational Status field displays "Normal operations" when

the stacking ports are cabled in the loop topology and all stacking
ports are operating normally.
The Operational Status field displays "Not all stack ports are up" if

the trunk ports are in the chain topology or trunk ports are unable to
establish links with their local or remote counterparts. Refer to
Chapter 11, "Troubleshooting" on page 147.
The priority numbers will be at the default 128. To change them to

match the switch ID numbers, continue with this procedure.
Depending on how you power on or reboot the stack in the future,

the switches might select a different master switch when forming
the stack. However, this does not change their ID numbers, their
configurations, or the manner in which you manage the stack.
x330 Series Installation Guide for Virtual Chassis Stacking
Priority Status
128 Ready
128 Ready
128 Ready
128 Ready
Normal operations
nnnn:nnnn:nnnn
Role
Active Master
Backup Member
Backup Member
Backup Member
113