Acl Configuration Commands; Common Configuration Commands; Display Acl Resource - 3Com S7906E Command Reference Manual

1

ACL Configuration Commands

Common Configuration Commands

display acl resource

Syntax
display acl resource [ slot slot-id ]
View
Any view
Default Level
1: Monitor level
Parameters
slot-id: Number of the slot.
Description
Use the display acl resource command to display the ACL uses on a switch.
Note that:
Using the command with a specified a slot will display the ACL uses of that slot. Otherwise, the
ACL uses of all slots of the device will be displayed.
If the board specified by the slot number is not in place or not working normally, this command will
display nothing.
Examples
# Display the ACL uses of all slots on the switch.
<Sysname> display acl resource
Interface:
Eth2/0/1 to Eth2/0/24
------------------------------------------------------------------------
Type Total
------------------------------------------------------------------------
IFP ACL 1024
IFP Meter 512
IFP Counter 512
Interface:
Eth2/0/25 to Eth2/0/48
------------------------------------------------------------------------
Reserved Configured
0 50
0 44
0 0
1-1
Remaining
974
468
512