Action-Qualifier Continuous Software Force Register And Mirror Register (Aqcsfrc / Aqcsfrcm); Action-Qualifier Continuous Software Force Register And Mirror Register (Aqcsfrc / Aqcsfrcm) Field Descriptions - Texas Instruments Concerto F28M35 Series Technical Reference Manual

Registers
Table 7-51. Action-Qualifier Software Force Register and Mirror Register (AQSFRC / AQSFRCM) Field
Bit Field
2 OTSFA
1:0 ACTSFA
Figure 7-102. Action-Qualifier Continuous Software Force Register and Mirror Register (AQCSFRC
15
7
Reserved
LEGEND: R/W = Read/Write; R = Read only; -n = value after reset
Table 7-52. Action-Qualifier Continuous Software Force Register and Mirror Register (AQCSFRC /
Bit Field
15-4 Reserved
3-2 CSFB
1-0 CSFA
752
C28 Enhanced Pulse Width Modulator (ePWM) Module
Descriptions (continued)
Value Description
One-Time Software Forced Event on Output A
0 Writing a 0 (zero) has no effect. Always reads back a 0.
This bit is auto cleared once a write to this register is complete ( i.e., a forced event is initiated).
1 Initiates a single software forced event
Action When One-Time Software Force A Is Invoked
00 Does nothing (action disabled)
01 Clear (low)
10 Set (high)
11 Toggle (Low → High, High → Low)
Note: This action is not qualified by counter direction (CNT_dir)
4
R-0
AQCSFRCM) Field Descriptions
Value Description
Reserved
Continuous Software Force on Output B
In immediate mode, a continuous force takes effect on the next TBCLK edge.
In shadow mode, a continuous force takes effect on the next TBCLK edge after a shadow load into
the active register. To configure shadow mode, use AQSFRC[RLDCSF].
00 Software forcing is disabled and has no effect
01 Forces a continuous low on output B
10 Forces a continuous high on output B
11 Software forcing is disabled and has no effect
Continuous Software Force on Output A
In immediate mode, a continuous force takes effect on the next TBCLK edge.
In shadow mode, a continuous force takes effect on the next TBCLK edge after a shadow load into
the active register.
00 Software forcing is disabled and has no effect
01 Forces a continuous low on output A
10 Forces a continuous high on output A
11 Software forcing is disabled and has no effect
Copyright © 2012–2019, Texas Instruments Incorporated
/ AQCSFRCM)
Reserved
R-0
3 2
CSFB
R/W-0
SPRUH22I – April 2012 – Revised November 2019
www.ti.com
8
1 0
CSFA
R/W-0
Submit Documentation Feedback