Calling A Third Subscriber And Transferring To An Active Communication Partner - Auerswald COMpact 5000 Operation Manual

Telephoning
Transferring

Calling a Third Subscriber and Transferring to an Active Communication Partner

You will automatically be reconnected with the waiting communication partner.
Note: On many ISDN phones, the termination of a query call on busy is not
performed automatically, but via a function key or via the menu (optional, see
manual for the telephone).
2. Press the Flash key or the Query key.
3. Dial ##07.
You will hear the confirmation tone.
4. Hang up the receiver.
The external communication partner continues to listen to hold music.
As soon as the internal subscriber hangs up the receiver or one subscriber logged in
to the group becomes available, this external communication partner is called. Once
he accepts the call, he is connected with the subscriber in the waiting loop.
Note: If the internal subscriber does not answer the call within 60 seconds or
the line remains busy during the three-minute waiting time, the call will be
transferred back to you. If you pick up the receiver, you will be reconnected
with the external communication partner. You can then place him in the
waiting loop again. If you do not pick up the call within 60 seconds, the
exchange line connection is disconnected completely (for example, if your
line was busy even for a short time).
Calling a Third Subscriber and Transferring to an Active Communication Partner
During a query call, proceed as follows:
1. Press the Flash key or the Query key.
2. Dial 5.
3. Enter a phone number. Possible entries:
162
COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016