Honda Accord 2008 Manual page 642

07/11/02 09:17:02 61TA0000_110_0323
14. Turn the ignition switch to LOCK (0).
15. Connect rocker arm oil control solenoid C 2P
connector terminals No. 1 and No. 2 with a jumper
wire.
＊０３
ROCKER ARM OIL CONTROL SOLENOID B 2P CONNECTOR
16. Turn the ignition switch to ON (II).
17. Select the VTEC TEST in the INSPECTION MENU,
and do the Solenoid Valve ACTIVATION of ROCKER
ARM SOLENOID B with the HDS.
Does the RET URN SIGNAL indicate ON when the
COMMAND is turned OF F ?
YES
oil control solenoid B terminal No. 1 and G101, then
go to step 18.
−
NO
(see page 11-328), then go to step 18.
GND (BLK) VTSB (GRN/RED)
JUMPER WIRE
Wire side of female terminals
− Repair open in the wire between rocker arm
Replace the rocker arm oil control valve
18. Turn the ignition switch to LOCK (0).
19. Reconnect all connectors.
20. Turn the ignition switch to ON (II).
21. Reset the PCM with the HDS.
22. Do the PCM idle learn procedure (see page 11-343).
23. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P2654 indicated?
−
YES Check for poor connections or loose
terminals at rocker arm oil control solenoid B and
the PCM, then go to step 1.
NO − Go to step 24.
24. Monitor the OBD STATUS for DTC P2654 in the
DTCs MENU with the HDS.
Does the screen indicate PASSED?
YES − Troubleshooting is complete. If any other
Temporary DTCs or DTCs were indicated in step 23,
go to the indicated DTC's troubleshooting.
NO − If the screen indicates FAILED, go to step 1
and recheck. If the screen indicates NOT
COMPLETED, keep idling until a result comes on.
(cont'd)
11-323