Vtc Oil Control Solenoid Valve Removal/Test/Installation - Honda Accord 2008 Manual

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:17:03 61TA0000_110_0325

VTC Oil Control Solenoid Valve Removal/Test/Installation

1. Disconnect the VTC oil control solenoid valve 2P

connector (A).

2. Remove the bolt (B) and the VTC oil control

solenoid valve (C).

3. Check the VTC oil control solenoid valve strainer

for clogging. If the strainer is clogged, replace the

VTC oil control solenoid valve.

4. Note the amount of valve opening by observing the

position of the piston shoulder (A) through the

valve retard drain port. If you see the shoulder of

the piston, the valve is open and must be replaced.

5. Connect the battery positive terminal to VTC oil

control solenoid valve 2P connector terminal No. 2.

VTC OIL CONTROL SOLENOID VALVE 2P CONNECTOR

Terminal side of male terminals

6. Connect the battery negative terminal to VTC oil

control solenoid valve 2P connector terminal No. 1.

Appearance of the inner valve (A) in the port should

be at least 0.09 in. (1.2 mm). If the inner valve does

not open, replace it; then go to step 7.

ＴＡ０８ＡＥ４Ａ１４６８０４６３３６５ＦＪＡＴ００

Table of Contents