Subaru LEGACY 2006 Manual page 3728

asieps_tobira.book 54 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MANUAL TRANSMISSION AND DIFFERENTIAL
5) Press-fit the ball bearing into the rear section of
transmission main shaft using ST1, ST2 and a
press.
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
6) Using the ST1 and ST2, install the 5th gear
thrust washer and 5th needle bearing race onto the
rear section of transmission main shaft.
NOTE:
• Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
• Face the thrust washer in the correct direction.
ST1 899714110 REMOVER
ST2 499877000 RACE 4-5 INSTALLER
(A) Face this surface to the 5th gear side.
7) Install the bearing onto the synchro cone.
Main Shaft Assembly for Single-range
ST2
ST1
MT-00194
(A)
MT-00195
5MT-54
8) Install the baulk ring and scynchro cone onto the
5th-Rev sleeve & hub assembly using the ST and a
press.
NOTE:
• Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
• Use a new ball bearing.
• After press-fitting, make sure the synchro cone
rotates smoothly.
ST 499757002 INSTALLER
(A) (B)
(A) Baulk ring
(B) Synchro cone
(C) Ball bearing
9) Install the synchro cone stopper and snap ring to
the 5th-Rev sleeve & hub assembly.
(B)
(A) Synchro cone stopper
(B) Snap ring
ST
(C)
MT-00196
(A)
MT-00188