Subaru LEGACY 2006 Manual page 3255

asieps_tobira.book 106 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
18) Install the leaf spring of the low & reverse
brake.
(A) Leaf spring
19) Install the 2-4 brake piston and 2-4 brake re-
tainer by aligning the hole of the 2-4 brake retainer
with the hole on the transmission case.
(B)
(A) 2-4 brake piston
(B) 2-4 brake piston retainer
20) Install 2-4 brake piston return spring to the
transmission case.
AT Main Case
(A)
AT-00293
(A)
AT-00287
AT-00286
4AT-106
21) Position the snap ring in the transmission. Us-
ing ST, press the snap ring into the specified loca-
tion.
ST 498677100 COMPRESSOR
S T
22) Install the planetary gear and low clutch as-
sembly to the transmission case.
Install carefully while rotating the low clutch and
planetary gear assembly slowly, paying special at-
tention not to damage the seal ring.
23) Place the dish plate, driven plate, drive plate
and retaining plate neatly in this order on surface
table.
24) Set the micro gauge to retaining plate, and read
its scale.
NOTE:
The value, which is read in the gauge at this time, is
zero point.
25) Scale and record the weight "Z" of a flat board
which will be put on retaining plate.
NOTE:
• Use a stiff board which does not bend against
load as a flat board to be put on retaining plate.
• Use a flat board weighing less than 100 N (10.2
kgf, 22.5 lb).
AT-00289
AT-00255