Subaru LEGACY 2006 Manual page 3258

asieps_tobira.book 109 ページ ２００９年１０月２６日 月曜日 午前９時１６分
38) Install the thrust needle bearing in the proper
direction.
(B)
(A) High clutch hub
(B) Thrust needle bearing
(C) Upside
(D) Downside
(E) Outside
39) Install the high clutch assembly.
(A)
(A) High clutch and reverse clutch ASSY
40) Adjust the total end play. <Ref. to 4AT-87, AD-
JUSTMENT, Oil Pump Housing.>
41) Install the thrust needle bearing in the proper
direction.
(A)
(A) High clutch and reverse clutch ASSY
(B) Thrust needle bearing
(C) Upside
(D) Downside
(E) Outside
AT Main Case
(C)
(E)
(D)
(A)
AT-02219
AT-00235
(C)
(B)
(E)
(D)
AT-02220
4AT-109
AUTOMATIC TRANSMISSION
42) Install a new gasket along with the oil pump
housing assembly. <Ref. to 4AT-83, INSPECTION,
Oil Pump Housing.>
43) Install the converter case to the transmission
case assembly. <Ref. to 4AT-81, INSTALLATION,
Converter Case.>
44) Insert the inhibitor switch and transmission
connector to the stay.
45) Install the air breather hose. <Ref. to 4AT-66,
INSTALLATION, Air Breather Hose.>
(B)
(A) Transmission connector
(B) Inhibitor switch connector
46) Install the oil cooler pipe. <Ref. to 4AT-64, IN-
STALLATION, ATF Cooler Pipe and Hose.>
47) Install the oil charge pipe together with an O-
ring. <Ref. to 4AT-67, INSTALLATION, Oil Charge
Pipe.>
48) Insert the input shaft while rotating it lightly by
hand, and then check the amount of protrusion.
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)
A
49) Install the torque converter assembly. <Ref. to
4AT-68, INSTALLATION, Torque Converter As-
sembly.>
50) Install the transmission assembly to the vehi-
cle. <Ref. to 4AT-38, INSTALLATION, Automatic
Transmission Assembly.>
(A)
AT-01351
AT-00291