Subaru LEGACY 2006 Manual page 3656

asieps_tobira.book 24 ページ ２００９年１０月２６日 月曜日 午前９時１６分
CLUTCH SYSTEM
5) Remove the stopper, clip and rod S, and remove
the spring and bushing S.
(E)
(D) (C)
(A) Clip
(B) Bushing S
(C) Spring S
(D) Rod S
(E) Stopper
6) Remove the stopper from the clutch pedal.
7) Remove the clutch pedal pad.
D: ASSEMBLY
1) Temporarily assemble the clutch switch, etc. to
pedal bracket.
2) Clean the clutch pedal and brake pedal bushing
holes, apply a thin coat of grease, and install the
bushings.
3) Align the holes of the pedal bracket, clutch pedal
and brake pedal, and install the brake pedal return
spring, assist rod, spring and bushing.
NOTE:
Clean the inside of bushings and apply a thin coat
of grease before installing the spacer.
Clutch Pedal
E: INSPECTION
1. CLUTCH PEDAL
Move the clutch pedal pads in the lateral direction
with a force of approximately 10 N (1 kgf, 2 lbf) to
check that the clutch pedal deflection is within the
(B)
service limit.
(A)
If it exceeds the service limit, replace with new
bushings.
Deflection of the clutch pedal:
Service limit
CL-00097
F: ADJUSTMENT
1) Measure the full stroke of the clutch pedal.
NOTE:
• Measure the leading end of the seat cushion and
center of the pedal.
• Align the seat with the seventh notch position
from the position at the very front.
Specified clutch pedal full stroke A:
Non-turbo model:
Turbo model:
CL-24
5.0 mm (0.197 in) or less
(B)
(A)
(A) Clutch pedal
(B) Brake pedal
130 — 135 mm (5.12 — 5.31 in)
135 — 140 mm (5.31 — 5.51 in)
A
(B)
(A)
(A) Clutch pedal (Full stroke condition)
(B) Scale
(C) Seat
CL-00098
(C)
CL-00078