Subaru LEGACY 2006 Manual page 3858

asieps_tobira.book 75 ページ ２００９年１０月２６日 月曜日 午前９時１６分
11) Remove the oil seal using ST or screwdriver.
ST 398527700 PULLER ASSY
12) Install a new oil seal with ST.
ST 498447120 OIL SEAL INSTALLER
13) Install the companion flange.
NOTE:
Use a plastic hammer to install companion flange.
14) Apply seal material on the drive pinion shaft
thread and new self-locking nut seat.
SEAL MATERIAL
THREE BOND 1324 (Part No. 004403042) or
equivalent
Rear Differential Front Oil Seal
ST
DI-00197
ST
DI-00292
DI-75
15) Tighten the self-locking nut within the specified
torque range so that the rotating resistance of com-
panion flange becomes the same as that of before
oil seal replacement.
ST 498427200 FLANGE WRENCH
NOTE:
Use a new self-locking nut.
Tightening torque:
T-type:
181.5 N·m (18.5 kgf-m, 134 ft-lb)
VA-type:
191 N·m (19.5 kgf-m, 141 ft-lb)
ST
16) Hereafter, reassemble in the reverse order of
disassembly.
DIFFERENTIALS
DI-00194