Subaru LEGACY 2006 Manual page 3779

asieps_tobira.book 60 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MANUAL TRANSMISSION AND DIFFERENTIAL
11) Remove the 1st driven gear, inner baulk ring,
synchro cone, outer baulk ring, 2nd gear bushing,
gear and hub using ST1 and ST2. (Turbo model)
(A)
(C)
(A) 1st driven gear
(B) Inner baulk ring
(C) Synchro cone
(D) Outer baulk ring
NOTE:
Replace the gear and hub if necessary. Because
these must engage at the specified point, avoid dis-
assembly as much as possible. If it must be disas-
sembled, mark the engaging point on the spline
beforehand.
ST1 499757002 INSTALLER
ST2 899714110 REMOVER
Drive Pinion Shaft Assembly
(D)
(B)
MT-00992
ST1
ST2
MT-00251
5MT-60
D: ASSEMBLY
1) Install the sleeve and hub assembly by matching
the alignment marks.
NOTE:
Use the new gear and hub assembly, if replacing
the gear or hub.
( B )
( A )
( C )
( D )
(A) 1st gear side
(B) 2nd gear side
(C) Flush surface
(D) Stepped surface
2) Install the washer to the 1st driven gear.
3) Install the 1st driven gear, 1st baulk ring, gear
and hub assembly onto the driven shaft. (Non-turbo
model)
(A) (B) (C)
(A) 1st driven gear
(B) 1st baulk ring
(C) Gear and hub ASSY
(D) 2nd gear bushing
MT-00252
(D)
MT-01224