Subaru LEGACY 2006 Manual page 3912

asieps_tobira.book 18 ページ ２００９年１０月２６日 月曜日 午前９時１６分
BRAKE
6) Install the caliper body to the support.
Tightening torque:
27 N·m (2.8 kgf-m, 19.9 ft-lb)
7) Connect the brake hose using a new brake hose
gasket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
8) Bleed air from the brake system.
2. 17-INCH TYPE
1) Install the support to the housing.
Tightening torque:
80 N·m (8.2 kgf-m, 59 ft-lb)
2) Apply a thin coat of Molykote M7439 to the pad
clip.
3) Apply a thin coat of Molykote AS880N (Part No.
K0777YA010) to the contact surface between pad
and inner shim.
4) Apply a thin coat of Molykote AS880N (Part No.
K0779YA010) to the three contact surfaces be-
tween inner shim and outer shim of outer pads.
Front Disc Brake Assembly
5) Install the pad to support.
NOTE:
Install the pad indicator in proper direction.
BR-00340
CAUTION:
• Be sure to install so that the pad return
spring faces the input side of the direction of
brake rotor rotation, as shown in the figure.
• Correctly install the pad return spring to the
supporting surface of the pad clip as shown in
the figure.
• If the pad return spring is deformed or dam-
BR-00238
aged, replace the brake pad.
BR-00341
BR-18
(1)
(2)
(6)
(3)
(6)
(5)
(4)
(1) LH – IN
(2) LH – OUT
(3) RH – IN
(4) RH – OUT
(5) Pad indicator
(6) Pad return spring
(1)
(3)
(1) Pad return spring
(2) Supporting surface of pad clip
(3) Direction of brake rotor rotation
(6)
(5)
(6)
BR-00342
(2)
BR-00483