Subaru LEGACY 2006 Manual page 3354

asieps_tobira.book 84 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
34.Drive Pinion Shaft Assembly
A: REMOVAL
1) Remove the transmission assembly from vehicle
body. <Ref. to 5AT-34, REMOVAL, Automatic
Transmission Assembly.>
2) Pull out the torque converter assembly. <Ref. to
5AT-63, REMOVAL, Torque Converter Assembly.>
3) Remove the transmission harness connector
from stay.
4) Disconnect the air breather hose. <Ref. to 5AT-
61, REMOVAL, Air Breather Hose.>
5) Remove the oil charge pipe. <Ref. to 5AT-62,
REMOVAL, Oil Charge Pipe.>
6) Remove the ATF filter inlet and outlet pipes.
<Ref. to 5AT-55, REMOVAL, ATF Filter.>
7) Separate the converter case and transmission
case. <Ref. to 5AT-78, REMOVAL, Converter
Case.>
8) Remove the drive pinion shaft mounting bolts,
and then remove the drive pinion shaft assembly
from oil pump cover.
9) Remove the oil pump cover from AT main case.
<Ref. to 5AT-80, Oil Pump Cover.>
Drive Pinion Shaft Assembly
B: INSTALLATION
1) Assemble the drive pinion assembly to oil pump
cover.
NOTE:
Be careful not to bend the shim.
Tightening torque:
70 N·m (7.1 kgf-m, 51.6 ft-lb)
2) Adjust the tooth contact between drive pinion
shaft assembly and the front differential side gear.
<Ref. to 5AT-87, ADJUSTMENT, Drive Pinion
Shaft Assembly.>
3) Join the converter case with the transmission
case. <Ref. to 5AT-78, INSTALLATION, Converter
Case.>
4) Install the transmission harness connector to the
stay.
5) Install the ATF filter pipe. <Ref. to 5AT-55, IN-
STALLATION, ATF Filter.>
6) Install the oil charge pipe with O-ring.
7) Install the torque converter assembly. <Ref. to
AT-01984
5AT-63, INSTALLATION, Torque Converter As-
sembly.>
8) Install the transmission assembly to the vehicle.
<Ref. to 5AT-37, INSTALLATION, Automatic
Transmission Assembly.>
5AT-84
AT-01984