Subaru LEGACY 2006 Manual page 3289

asieps_tobira.book 64 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
B: INSTALLATION
1) Install the oil cooler inlet and outlet pipes with
new washers.
Tightening torque:
T1: 25 N·m (2.5 kgf-m, 18 ft-lb)
T2: 40 N·m (4.1 kgf-m, 29.5 ft-lb)
T3: 44 N·m (4.5 kgf-m, 32.5 ft-lb)
T1
2) Install the ATF cooler pipe to frame.
ATF Cooler Pipe and Hose
3) Connect the ATF cooler hose to the pipe on the
transmission side.
NOTE:
• Install so that the hose is not folded over, exces-
sively bent or twisted.
• Insert the hose to the specified position.
T2
T3
4) Connect the ATF cooler hose to the pipe on the
AT-03072
radiator side.
NOTE:
• Install so that the hose is not folded over, exces-
sively bent or twisted.
• Insert the hose to the specified position.
5) Install the radiator under cover.
AT-01347
6) Install the under cover.
7) Install the battery.
8) Fill the ATF. <Ref. to 4AT-26, Automatic Trans-
mission Fluid.>
NOTE:
Make sure there are no ATF leaks in joints between
the transmission, radiator, pipes, and hoses.
4AT-64
AT-01333
AT-01345
AT-03402