Subaru LEGACY 2006 Manual page 4088

asieps_tobira.book 11 ページ ２００９年１０月２６日 月曜日 午前９時１６分
9) Tighten the nuts and bolts which hold the rear
arm, front link, rear link, upper link and shock ab-
sorber.
NOTE:
Always tighten the stabilizer bushing in the state
where the vehicle is at curb weight and the wheels
are in full contact with the ground.
(1)
(1) Rear arm
(2) Transmission jack
10) Install the sub frame support arm.
NOTE:
Inspect the wheel alignment and adjust it if neces-
sary.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion" for the tightening torque. <Ref. to RS-3,
REAR SUSPENSION, COMPONENT, General
Description.>
Rear Arm
(2)
RS-00052
RS-11
C: DISASSEMBLY
1. FRONT BUSHING
1) Set the ST A with the larger side of its inner di-
ameter turned upward.
2) Set the rear arm with the protruding side of bush-
ing turned upward.
3) Place the ST B on bushing, and push the bush-
ing out.
ST-A 20099AE020INSTALLER & REMOVER
SET
ST-B 20099AE020INSTALLER & REMOVER
SET
ST-B
ST-A
(1) Bushing
2. REAR BUSHING
Using the ST C and bearing puller, press the rear
bushing out.
ST-C 20099AE040INSTALLER & REMOVER
SET
ST-C
(1)
(1) Bearing puller
REAR SUSPENSION
(1)
RS-00119
RS-00054