Subaru LEGACY 2006 Manual page 3339

asieps_tobira.book 42 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
10.Transmission Mounting Sys-
tem
A: REMOVAL
1. PITCHING STOPPER
1) Disconnect the ground cable from the battery.
2) Remove the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-12, REMOVAL, Intercool-
er.>
3) Remove the air intake chamber. (Non-turbo
model) <Ref. to IN(H6DO)-7, REMOVAL, Air Intake
Chamber.>
4) Remove the pitching stopper.
2. TRANSMISSION REAR CROSSMEMBER
AND REAR CUSHION RUBBER
1) Disconnect the ground cable from the battery.
2) Jack-up the vehicle and support it with rigid
racks.
3) Remove the center and rear exhaust pipes and
the muffler. (Turbo model)
<Ref. to EX(H4DOTC)-8, REMOVAL, Center Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-12, REMOV-
AL, Rear Exhaust Pipe.> <Ref. to EX(H4DOTC)-
13, REMOVAL, Muffler.>
4) Remove the front exhaust pipe, rear exhaust
pipe and muffler. (Non-turbo model) <Ref. to
EX(H6DO)-4, REMOVAL, Front Exhaust Pipe.>
<Ref. to EX(H6DO)-7, REMOVAL, Rear Exhaust
Pipe.> <Ref. to EX(H6DO)-9, REMOVAL, Muffler.>
5) Remove the heat shield cover.
6) Set the transmission jack under transmission.
Make sure that the support plate of transmission
jack does not touch the oil pan.
Transmission Mounting System
7) Remove the transmission rear crossmember.
8) Remove the rear cushion rubber from transmis-
sion.
B: INSTALLATION
1. PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N·m (5.9 kgf-m, 42.8 ft-lb)
AT-01368
2) Install the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-12, INSTALLATION, Inter-
cooler.>
3) Install the air intake chamber. (Non-turbo model)
<Ref. to IN(H6DO)-7, INSTALLATION, Air Intake
Chamber.>
4) Connect the ground cable to battery.
5AT-42
AT-01377
T2
T1
AT-01380