Subaru LEGACY 2006 Manual page 3911

asieps_tobira.book 17 ページ ２００９年１０月２６日 月曜日 午前９時１６分
4. Front Disc Brake Assembly
A: REMOVAL
1. 16-INCH TYPE
CAUTION:
Do not allow brake fluid to come in contact with
vehicle body. If it does, wash off with water and
wipe away completely.
1) Lift-up the vehicle, and remove the front wheels.
2) Remove the union bolt, and disconnect the
brake hose from the caliper body assembly.
3) Remove the bolt securing the lock pin to caliper
body.
4) Raise the caliper body, and then move it toward
vehicle center to separate it from the support.
5) Remove the support from housing.
NOTE:
Remove the support only when replacing the rotor
or support. It need not be removed when servicing
the caliper body assembly.
Front Disc Brake Assembly
6) Remove mud and foreign matter from the caliper
body assembly and the support.
2. 17-INCH TYPE
Refer to 16-inch type. <Ref. to BR-17, 16-INCH
TYPE, REMOVAL, Front Disc Brake Assembly.>
B: INSTALLATION
1. 16-INCH TYPE
1) Install the support to the housing.
Tightening torque:
80 N·m (8.2 kgf-m, 59 ft-lb)
2) Apply a thin coat of Molykote M7439 (Part No.
003602001) to the pad clip.
BR-00021
3) Apply a thin coat of Molykote AS880N (Part No.
K0777YA010) to the contact surface between pad
and inner shim.
BR-00022
4) Apply a thin coat of Molykote AS880N (Part No.
K0777YA010) to the three contact surfaces be-
tween inner shim and outer shim of outer pads.
BR-00023
5) Install the pad to support.
BR-17
BRAKE
BR-00340
BR-00238
BR-00341