Subaru LEGACY 2006 Manual page 3624

asieps_tobira.book 134 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
16.General Diagnostic Table
A: INSPECTION
Symptoms
Shifting vehicle speed is low on "D" range.
Shifting vehicle speed is high on "D" range.
Excessive shock. ("N"→"D" range)
Excessive shift shock on 1st of "D" range → 2nd of "D"
range or "1st of manual mode" → "2nd of manual mode".
Excessive shift shock on 2nd of "D" range → 3rd of "D"
range or "2nd of manual mode" → "3rd of manual mode".
Excessive shift shock on 3rd of "D" range → 4th of "D"
range or "3rd of manual mode" → "4th of manual mode".
General Diagnostic Table
• Vehicle speed sensor 1 and vehicle speed sensor 2
• Accelerator pedal position sensor
• Throttle position sensor
• ATF temperature sensor
• CAN communication signal
• Vehicle speed sensor 1 and vehicle speed sensor 2
• Accelerator pedal position sensor
• Throttle position sensor
• CAN communication signal
• Brake switch signal
• Lateral G sensor
• ATF temperature sensor
• Engine idle speed
• Engine speed signal
• Accelerator pedal position sensor
• Throttle position sensor
• Control cable adjustment
• ATF temperature sensor
• Oil pressure switch 1 and front brake solenoid valve
• CAN communication signal
• Fluid level and condition
• TCM power supply
• PVIGN relay
• Accelerator pedal position sensor
• Throttle position sensor
• Control cable adjustment
• Oil pressure switch 4 and direct clutch solenoid valve
• CAN communication signal
• Engine speed signal
• Turbine speed sensor 1 and turbine speed sensor 2
• Vehicle speed sensor 1 and vehicle speed sensor 2
• Fluid level and condition
• Accelerator pedal position sensor
• Throttle position sensor
• Control cable adjustment
• Oil pressure switch 5 and high & low reverse clutch solenoid valve
• CAN communication signal
• Engine speed signal
• Turbine speed sensor 1 and turbine speed sensor 2
• Vehicle speed sensor 1 and vehicle speed sensor 2
• Fluid level and condition
• Accelerator pedal position sensor
• Throttle position sensor
• Control cable adjustment
• Oil pressure switch 3 and input clutch solenoid valve
• CAN communication signal
• Engine speed signal
• Turbine speed sensor 1 and turbine speed sensor 2
• Vehicle speed sensor 1 and vehicle speed sensor 2
• Fluid level and condition
5AT(diag)-134
Problem parts