Subaru LEGACY 2006 Manual page 3655

asieps_tobira.book 23 ページ ２００９年１０月２６日 月曜日 午前９時１６分
10.Clutch Pedal
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the steering column. <Ref. to PS-17,
REMOVAL, Tilt Steering Column.>
3) Disconnect the connectors of the stop light
switch and clutch switch.
4) Remove the snap pins from clevis pins which se-
cure the lever to the push rod and operating rod.
5) Pull out the clevis pins which secures the lever to
the push rod and operating rod.
(A)
(D)
(C)
(A) Operating rod
(B) Push rod
(C) Snap pin
(D) Clevis pin
6) Remove the nut which secures the clutch master
cylinder.
7) Remove the bolt which secures the brake pedal
and clutch pedal, and remove the pedal assembly.
B: INSTALLATION
1) Install in the reverse order of removal.
Tightening torque:
T: 18 N·m (1.8 kgf-m, 13.0 ft-lb)
CAUTION:
Always use a new clevis pin.
2) Adjust the clutch pedal after installation. <Ref. to
CL-24, ADJUSTMENT, Clutch Pedal.>
Clutch Pedal
C: DISASSEMBLY
1) Remove the clutch switches.
2) Remove the clip, assist spring, rod and bushing.
(D)
(A) Clip
(B) Assist spring
(C) Assist rod
(D) Bushing
(E) Clevis pin
(C)
(B)
3) Extract the spring pin and remove the lever.
CL-00292
(A) Pin
(B) Lever
4) Remove the clutch pedal and bushing.
CL-00093
(A) Clutch pedal
(B) Bushing
CL-23
CLUTCH SYSTEM
(D)
(A)
(E)
(C)
(D)
(D)
(B)
(E)
(C)
CL-00094
(A)
CL-00095
(B)
(A)
CL-00096
(B)
(B)