Subaru LEGACY 2006 Manual page 3443

asieps_tobira.book 57 ページ ２００９年１０月２６日 月曜日 午前９時１６分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
P: DTC P0748 PRESSURE CONTROL SOLENOID "A" ELECTRICAL
DTC DETECTING CONDITION:
Output signal circuit of line pressure linear solenoid is open or shorted.
TROUBLE SYMPTOM:
Excessive shift shock
WIRING DIAGRAM:
Step
1 CHECK HARNESS CONNECTOR BETWEEN
TCM AND TRANSMISSION.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from transmis-
sion and TCM.
3) Measure the resistance of the harness
between TCM connector and transmission
connector.
Connector & terminal
(B55) No. 19 — (B11) No. 2:
(B55) No. 20 — (B11) No. 1:
2 CHECK HARNESS CONNECTOR BETWEEN
TCM AND CHASSIS GROUND.
Measure the resistance of the harness
between TCM connector and chassis ground.
Connector & terminal
(B55) No. 19 — Chassis ground:
(B55) No. 20 — Chassis ground:
3 CHECK LINE PRESSURE LINEAR SOLE-
NOID.
Measure the resistance between transmission
connector receptacle's terminals.
Connector & terminal
(T4) No. 1 — No. 2:
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
B55 TCM
B11
T4
AT11
LINE
PRESSURE
LINEAR
SOLENOID
TRANSMISSION
Check
Is the resistance less than 1
Ω?
Is the resistance more than 1
MΩ?
Is the resistance between 4 —
8 Ω?
4AT(diag)-57
B11
3 4
1 2
5 6 7 8
9 10 11 12
14 15
13 16
17 18 20
19
B55
1 2 3 4 5 6 7 8 9
10 11 12 13 14 15 16 17 18 19 20 21
22 23 24 25 26 27 28 29 30 31
AT11
1 2
3 4
AT-03412
Yes No
Go to step 2.
Repair the open
circuit of harness
between TCM and
transmission con-
nector.
Go to step 3.
Repair the short
circuit of harness
between TCM and
transmission con-
nector.
Go to step 5. Go to step 4.