Subaru LEGACY 2006 Manual page 3235

asieps_tobira.book 52 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
4) Apply an adequate amount of liquid gasket to the
three holes excluding the screw holes of the trans-
mission case.
Liquid gasket:
THREE BOND 1217B (Part No. K0877YA020)
5) Install the oil pan.
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
6) Install the front vehicle speed sensor and torque
converter turbine speed sensor.
Tightening torque:
7 N·m (0.7 kgf-m, 5.1 ft-lb)
7) Connect the connector to the rear vehicle speed
sensor.
8) Install the oil cooler pipe.
NOTE:
Use a new copper washer.
Tightening torque:
T1: 25 N·m (2.5 kgf-m, 18 ft-lb)
T2: 40 N·m (4.1 kgf-m, 29.5 ft-lb)
T3: 44 N·m (4.5 kgf-m, 32.5 ft-lb)
T1
9) Install the transmission rear crossmember bolt.
Tightening torque:
75 N·m (7.6 kgf-m, 55 ft-lb)
10) Install the propeller shaft. <Ref. to DS-11, IN-
STALLATION, Propeller Shaft.>
11) Install the shield cover.
Front Vehicle Speed Sensor
12) Install the front, center and rear exhaust pipes,
and the muffler.
<Ref. to EX(H4SO)-5, INSTALLATION, Front Ex-
haust Pipe.> <Ref. to EX(H4SO)-8, INSTALLA-
TION, Rear Exhaust Pipe.> <Ref. to EX(H4SO)-10,
INSTALLATION, Muffler.>
13) Lower the vehicle.
14) Install the transmission connector to the stay.
15) Install the pitching stopper. <Ref. to 4AT-42,
INSTALLATION, Transmission Mounting System.>
16) Install the air intake chamber.
<Ref. to IN(H4SO)-7, INSTALLATION, Air Intake
Chamber.>
17) Fill with the same amount of ATF as drained.
18) Bleed the air of control valve.
<Ref. to 4AT-60, Air Bleeding of Control Valve.>
AT-01339
19) Inspect the level of ATF. <Ref. to 4AT-26, Au-
tomatic Transmission Fluid.>
20) Execute the learning control promotion. <Ref.
to 4AT(diag)-16, FACILITATION OF LEARNING
CONTROL, OPERATION, Subaru Select Moni-
tor.>
T2
T3
AT-03072
4AT-52