Subaru LEGACY 2006 Manual page 3717

asieps_tobira.book 23 ページ ２００９年１０月２６日 月曜日 午前９時１６分
2. Transmission Gear Oil
A: INSPECTION
1) Park the vehicle on a level surface.
2) Turn the ignition switch to OFF, and wait until the
engine cools.
3) Remove the oil level gauge and wipe it clean.
4) Reinsert the level gauge all the way. Be sure that
the level gauge is correctly inserted in the proper
direction.
5) Pull out the oil level gauge again, and check the
oil level. If it is below the lower level, add oil through
the oil level gauge hole to bring the level up to the
upper level.
(A)
(A) Oil level gauge
(B) Upper level
(C) Lower level
Transmission Gear Oil
MANUAL TRANSMISSION AND DIFFERENTIAL
B: REPLACEMENT
1) Pull out the oil level gauge.
2) Lift-up the vehicle.
3) Drain transmission gear oil completely.
CAUTION:
Be careful not to burn yourself, because trans-
mission gear oil becomes extremely hot after
running.
NOTE:
• Tighten the drain plug of the transmission gear
oil after draining the transmission gear oil.
• Use a new gasket.
Tightening torque:
44 N·m (4.5 kgf-m, 33 ft-lb) (Aluminum gas-
ket)
70 N·m (7.1 kgf-m, 51 ft-lb) (Copper gasket)
(B)
(C)
PM-00030
(A) Drain plug
(B) Gasket
4) Lower the vehicle.
5) Pour gear oil through the gauge hole.
Recommended gear oil:
GL-5 (75W-90) or equivalent
Gear oil capacity:
3.5 (3.7 US qt, 3.1 Imp qt)
2
6) Check the level of the transmission gear oil.
CAUTION:
The level should be within the specified range
marked on the gauge.
5MT-23
(B)
(A)
MT-00061