Subaru LEGACY 2006 Manual page 3971

asieps_tobira.book 17 ページ ２００９年１０月２６日 月曜日 午前９時１６分
4. Front Hub Unit Bearing
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift-up the vehicle, and remove the front wheels.
3) Lift the crimped section of axle nut.
4) Remove the axle nut using a socket wrench
while depressing the brake pedal.
CAUTION:
Remove the wheel before loosening the axle
nut. Failure to follow this rule may damage the
wheel bearings.
5) Remove the disc brake caliper from the housing,
and suspend it from strut using a wire.
6) Remove the disc rotor from the hub.
NOTE:
If it is difficult to remove the disc rotor from the hub,
drive the 8 mm bolt into the threaded end of rotor,
and then remove the rotor.
Front Hub Unit Bearing
7) Remove the four bolts from the housing.
(A) Housing
CAUTION:
• Do not get closer the tool which charged
DS-00038
magnetism to magnetic encoder.
• Be careful not to damage the magnetic en-
coder.
(1) Magnetic encoder
(2) Front hub unit bearing
8) Remove the front hub unit bearing. If it is hard to
remove, use the ST.
ST1 926470000
ST2 28099PA110 AXLE SHAFT PULLER
DS-00041
DS-17
DRIVE SHAFT SYSTEM
(A)
(2)
(1)
AXLE SHAFT PULLER
PLATE
ST1
ST2
DS-00231
DS-00250
DS-00145