Subaru LEGACY 2006 Manual page 3256

asieps_tobira.book 107 ページ ２００９年１０月２６日 月曜日 午前９時１６分
26) Put the flat board on retaining plate.
27) Using the following formula, read the push/pull
gauge, and calculate "N".
N = 100 N (10.2 kgf, 22.5 lb) – Z
N: Value indicated on push/pull gauge
100 N (10.2 kgf, 22.5 lb) : Load applied to clutch
plate
Z: Flat board weight
28) Press the center of retaining plate by applying a
force of N using push/pull gauge, and then mea-
sure and record the height A. Measure at three lo-
cations or more spaced by equal distances and
take the average value.
NOTE:
If measuring in three locations, measure every
120°. If measuring in four locations, measure every
90°.
A
(A) Driven plate
(B) Drive plate
(C) Retaining plate
AT Main Case
29) Install the pressure plate, drive plate, driven
plate, retaining plate and snap ring.
AT-01720
30) Install a new 2-4 brake oil seal to the transmis-
sion case.
31) After all 2-4 brake component parts have been
installed, blow in air intermittently and confirm the
operation of the brake.
32) Measure the clearance B between the retaining
plate and snap ring.
(C)
(B)
(A)
AT-01723
4AT-107
AUTOMATIC TRANSMISSION
AT-00254
AT-02215
AT-00290
B
AT-01724