Subaru LEGACY 2006 Manual page 3720

asieps_tobira.book 31 ページ ２００９年１０月２６日 月曜日 午前９時１６分
5. Oil Seal
A: INSPECTION
Check for leakage of gear oil from the oil seal. If
there is oil leakage, replace with a new oil seal.
B: REPLACEMENT
1) Clean the transmission exterior.
2) Drain gear oil completely.
NOTE:
• Tighten the drain plug of the transmission gear
oil after draining the gear oil.
• Use a new gasket.
Tightening torque:
44 N·m (4.5 kgf-m, 33 ft-lb) (Aluminum gas-
ket)
70 N·m (7.1 kgf-m, 51 ft-lb) (Copper gasket)
3) Remove the rear exhaust pipe and muffler.
<Ref. to EX(H4SO)-8, REMOVAL, Rear Exhaust
Pipe.> <Ref. to EX(H4SO)-10, REMOVAL, Muf-
fler.>
4) Remove the heat shield cover. (If equipped)
5) Remove the propeller shaft. <Ref. to DS-10, RE-
MOVAL, Propeller Shaft.>
6) Using the ST, remove the oil seal.
ST 398527700 PULLER ASSY
(A)
(A) Oil seal
Oil Seal
7) Using the ST, install the oil seal.
ST 498057300
8) Install the propeller shaft. <Ref. to DS-11, IN-
STALLATION, Propeller Shaft.>
9) Install the heat shield cover. (If equipped)
10) Install the rear exhaust pipe and muffler. <Ref.
to EX(H4SO)-8, INSTALLATION, Rear Exhaust
Pipe.> <Ref. to EX(H4SO)-10, INSTALLATION,
Muffler.>
11) Pour in gear oil and check the oil level. <Ref. to
5MT-23, REPLACEMENT, Transmission Gear
Oil.>
MT-00097
ST
MT-00098
5MT-31
MANUAL TRANSMISSION AND DIFFERENTIAL
INSTALLER
MT-00099