Subaru LEGACY 2006 Manual page 3679

asieps_tobira.book 27 ページ ２００９年１０月２６日 月曜日 午前９時１６分
11.Clutch Switch
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the instrument panel lower cover.
3) Disconnect the connector from clutch switch.
4) Remove the clutch switches.
B: INSTALLATION
1. CLUTCH SWITCH (WITH CRUISE CON-
TROL)
1) Install so that there is a gap of 0 mm (0 in) of the
clutch switch and clutch pedal stopper.
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
(C)
(B)
(A) Clutch switch
(B) Stopper
(C) 0 mm (0 in)
2) Measure the stroke of the clutch pedal.
Clutch pedal standard full stroke: A
Non-turbo model
130 — 135 mm (5.12 — 5.31 in)
Turbo model
135 — 140 mm (5.31 — 5.51 in)
A
(A)
(A) Clutch pedal (Full stroke condition)
(B) Scale
(C) Seat
Clutch Switch
(A)
CL-00103
(C)
(B)
CL-00078
CL-27
3) If the clutch pedal stroke is out of specification,
adjust the stroke. <Ref. to CL-24, ADJUSTMENT,
Clutch Pedal.>
4) Connect the clutch switch connector.
2. CLUTCH SWITCH (CLUTCH START)
1) Fully depress the clutch and hold it.
2) Install the clutch pedal plate and clutch pedal so
that the gap between them is 2 — 2.5 mm (0.08 —
0.10 in), and then tighten the lock nut.
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
(A)
(C)
(A) Plate
(B) Clutch pedal
(C) 2 — 2.5 mm (0.08 — 0.10 in)
3) Connect the clutch switch connector.
4) Make sure that engine does not start with clutch
pedal not depressed.
5) Make sure that engine starts with clutch pedal
fully depressed.
CLUTCH SYSTEM
(B)
CL-00104