Subaru LEGACY 2006 Manual page 3657

asieps_tobira.book 25 ページ ２００９年１０月２６日 月曜日 午前９時１６分
2) If the full stroke is not within the specified value,
loosen the clutch switch lock nut to adjust.
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
3) Loosen the push rod lock nuts.
(D)
(C)
(A) Clevis pin
(B) Snap pin
(C) Push rod
(D) Push rod lock nut
4) Rotate the push rod to adjust.
(1) Make sure that the clutch pedal contacts the
clutch switch side when the pedal is released.
(2) Make sure that the clutch pedal contacts the
clutch pedal bracket stopper when the clutch
pedal is at the maximum stroke position.
(A)
(B)
(C)
(D)
(A) Clevis hole
(B) Push rod lock nut
(C) In the shorter direction
(D) In the longer direction
(E) Push rod
(F) U shaped hardware
Clutch Pedal
(A)
(B)
CL-00042
(F)
(E)
CL-00080
CL-25
5) Turn the push rod to shorten until a clearance is
gained on the clutch switch side.
(C)
(B)
(A) Clutch switch
(B) Stopper
(C) Clearance
6) Turn the push rod to lengthen until clutch pedal
contacts the clutch switch.
7) Turn further in the direction that will shorten the
push rod (arrow direction shown in figure) by 270°.
(A)
(A) Accelerator pedal
(B) Clevis
8) Check that the clevis pin moves smoothly by
moving it in the left and right directions.
9) Tighten the push rod lock nut.
Tightening torque:
10 N·m (1.0 kgf-m, 7.2 ft-lb)
10) Depress and release the clutch pedal two or
three times to ensure that the clutch pedal and re-
lease fork operate smoothly. If the clutch pedal and
release fork do not operate smoothly, bleed air
from the clutch hydraulic system. <Ref. to CL-22,
Clutch Fluid Air Bleeding.>
CLUTCH SYSTEM
(A)
CL-00132
(B)
CL-00101