Drive Plate - Subaru LEGACY 2006 Manual

asieps_tobira.book 64 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION

25.Drive Plate

A: REMOVAL
1) Remove the transmission assembly from the ve-
hicle. <Ref. to 5AT-34, REMOVAL, Automatic
Transmission Assembly.>
2) Use the ST to lock the crankshaft, and remove
the drive plate.
ST 498497100 CRANKSHAFT STOPPER
B: INSTALLATION
1) Temporarily tighten the drive plate.
2) Using the ST, lock the crankshaft.
ST 498497100 CRANKSHAFT STOPPER
ST
3) Tighten the drive plate in three stages. (turbo
model)
(1) Tighten the drive plate mounting bolt.
Tightening torque:
10 N·m (1.0 kgf-m, 7.4 ft-lb)
(2) Additionally tighten the drive plate mounting
bolts.
Tightening torque:
40 N·m (4.1 kgf-m, 29.5 ft-lb)
(3) While checking the tightening angle with the
ST, further tighten the drive plate mounting
bolts.
Tightening angle:
±
30° 5°
ST 18854AA000 ANGLE GAUGE
4) Tighten the drive plate to the specified torque.
(non-turbo model)
Drive Plate
NOTE:
Tighten the drive plate mounting bolts gradually.
Each bolt should be tightened in a crisscross order.
Tightening torque:
81 N·m (8.3 kgf-m, 60 ft-lb)
5) Install the transmission assembly to the vehicle.
<Ref. to 5AT-37, INSTALLATION, Automatic
Transmission Assembly.>
ST
ME-00136
AT-05096
5AT-64