Subaru LEGACY 2006 Manual page 3367

asieps_tobira.book 97 ページ ２００９年１０月２６日 月曜日 午前９時１６分
B: INSTALLATION
1) Apply ATF to new seal rings.
2) Install the thrust bearings and new seal rings to
the drum support.
(A)
(B)
(A)
(A)
(A) Thrust bearing
(B) Seal ring
3) Install the reverse brake piston.
NOTE:
Apply ATF onto the piston sliding surface.
ST1 18762AA000 COMPRESSOR SPECIAL
TOOL
ST2 18765AA000 COMPRESSOR SUPPORT
ST3 18763AA000 COMPRESSOR SHAFT
4) Install the return spring.
AT Main Case
(A)
(B)
AT-04306
AT-02002
5AT-97
AUTOMATIC TRANSMISSION
5) Install the spring retainer and snap ring.
ST1 18762AA000 COMPRESSOR SPECIAL
TOOL
ST2 18765AA000 COMPRESSOR SUPPORT
ST3 18763AA000 COMPRESSOR SHAFT
ST3
6) Install the dish plate.
NOTE:
When installing, make sure that the identification
mark is facing the front side of transmission.
7) Install the drive plate and driven plate.
ST1
ST2
AT-02000