Subaru LEGACY 2006 Manual page 3783

asieps_tobira.book 64 ページ ２００９年１０月２６日 月曜日 午前９時１６分
MANUAL TRANSMISSION AND DIFFERENTIAL
• If the gap between the end faces of the ring and
the gear spindle part is excessively small, check
the clearance (A) while pressing the ring against
the cone.
Clearance (A):
0.5 — 1.0 mm (0.020 — 0.040 in)
(A)
• When the contact surface of synchronizer ring in-
sert is scratched or abnormally worn.
5) Shifting insert key
Replace the insert key if deformed, excessively
worn or defective in any way.
(A)
(A) Insert key
6) Oil seal
Replace the oil seal if the lip is deformed, hard-
ened, worn or defective in any way.
7) O-ring
Replace the O-ring if the sealing face is deformed,
hardened, damaged, worn or defective in any way.
Drive Pinion Shaft Assembly
F: ADJUSTMENT
1. THRUST BEARING PRELOAD
1) Select a suitable adjusting washer No.1 to so
that dimension (H) will be zero in a visual check.
Position the washer (18.3 × 30 × 4) and lock wash-
er (18 × 30 × 2) and install lock nut (18 × 13.5).
MT-00265
2) Using the ST1, ST2 and ST3, tighten the new
lock nut to the specified torque.
ST1 899884100
MT-00989
ST2 498427100
ST3 899988608
Tightening torque:
120 N·m (12.2 kgf-m, 88.5 ft-lb)
5MT-64
(H)
MT-00267
HOLDER
STOPPER
SOCKET WRENCH (27)
ST1
ST2
ST3
MT-00268