Subaru LEGACY 2006 Manual page 3315

asieps_tobira.book 17 ページ ２００９年１０月２６日 月曜日 午前９時１６分
C: CAUTION
• Wear appropriate work clothing, including a cap,
protective goggles and protective shoes when per-
forming any work.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Until the oil pan is removed, do not place with the
oil pan side facing up to prevent foreign matter from
entering the valve body.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, disassembly and replacement.
• When disassembling the case and other light al-
loy parts, disassemble them by slightly tapping with
a plastic hammer. Do not pry apart with screwdriv-
ers or other tools.
• Vehicle components are extremely hot after driv-
ing. Be wary of receiving burns from heated parts.
D: PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION
ST-498575400
ST-498897200
General Description
• Use SUBARU genuine gear oil, grease or the
equivalent. Do not mix them of different grades or
manufacturers.
• Be sure to tighten bolts and nuts to the specified
torque.
• Place shop jacks or rigid racks at the specified
points.
• Apply gear oil onto sliding or revolving surfaces
before installation.
• Replace deformed or damaged snap rings with
new parts.
• Before installing O-rings or oil seals, apply suffi-
cient amount of ATF fluid to avoid damage and de-
formation.
• Be careful not to incorrectly install or fail to install
O-rings, snap rings and other such parts.
• Before securing a part on a vise, place cushion-
ing material such as wood blocks, aluminum plate,
or cloth between the part and the vise.
• Avoid damaging the mating surface of the case.
• Before applying liquid gasket, completely re-
move the old seal.
TOOL NUMBER DESCRIPTION
498575400 OIL PRESSURE
GAUGE ASSY
498897200 ADAPTER
5AT-17
AUTOMATIC TRANSMISSION
REMARKS
Used for measuring oil pressure.
Used with oil pump cover installed on when mea-
suring line pressure.