Subaru LEGACY 2006 Manual page 3887

asieps_tobira.book 68 ページ ２００９年１０月２６日 月曜日 午前９時１６分
DIFFERENTIALS
14) Assemble holders.
(1) Install the new oil seal into holder RH and
LH.
ST 498447100 INSTALLER
ST
(2) Install the bearing race into holder RH and
LH.
ST 398177700 INSTALLER
CAUTION:
Make sure that the RH and LH oil seals, bearing
outer races and cones are properly assembled.
ST
(3) Install the differential assembly into differen-
tial carrier in the reverse order of disassembly.
(4) Temporally tighten the side holders RH and
LH in differential carrier to install.
Rear Differential (VA-type)
15) Perform the backlash adjustment between the
hypoid driven gear and drive pinion, and preload
adjustment of differential side bearing.
(1) Turn the drive pinion with ST for better fitting
of differential side bearing.
ST 498427200
DI-00166
(2) Screw in the side holder LH until light con-
tact is made with ST.
ST 18630AA010 WRENCH
(3) Back off the holder on the hypoid driven
DI-00167
gear side by approx.1 and 1/2 teeth, and tighten
the other side holder by approx. 2 teeth (amount
that the hypoid driven gear is turned back (1
and 1/2) + 1/2 teeth).
[Back off amount of side (hypoid driven gear
side) holder + 1/2 tooth.] This + 1/2 tooth gives
preload.
(4) Temporarily tighten the lock plate.
NOTE:
Turn over the lock plate to shift the holder by 1/2
tooth.
DI-00366
DI-68
FLANGE WRENCH
ST
DI-00385
ST
DI-00399
DI-00364