Rear Link - Subaru LEGACY 2006 Manual

asieps_tobira.book 18 ページ ２００９年１０月２６日 月曜日 午前９時１６分
REAR SUSPENSION

8. Rear Link

A: REMOVAL
1) Lift up the vehicle, and then remove the rear
wheels.
2) Remove the rear stabilizer. <Ref. to RS-8, RE-
MOVAL, Rear Stabilizer.>
3) Support the rear arm horizontally using a trans-
mission jack.
(1)
(1) Rear arm
(2) Transmission jack
4) Remove the bolts which secures the rear link to
the rear arm.
5) Place alignment marks on the rear link adjusting
bolt and sub frame.
6) Remove the bolt which secures the rear link to
the sub frame, then remove the rear link.
CAUTION:
When loosening the adjusting bolt, make sure
to fix the bolt head in place when loosening the
nut.
Rear Link
(2)
RS-00052
RS-00080
RS-00081
RS-18
B: INSTALLATION
1) Support the rear arm horizontally using a trans-
mission jack.
2) Using new self-locking nuts, install the rear link.
(1)
(2)
(1) Rear arm
(2) Transmission jack
NOTE:
• Tighten the self-locking nut with the bolt head
fixed in place when installing the adjusting bolt.
• Inspect the wheel alignment and adjust it if nec-
essary.
Tightening torque:
Rear link-to-Sub frame
120 N·m (12.2 kgf-m, 89 ft-lb)
Rear link-to-Rear arm
120 N·m (12.2 kgf-m, 89 ft-lb)
C: DISASSEMBLY
Using the ST A and ST B, press the bushing out.
ST-A 20099AE000INSTALLER & REMOVER
ST-B 20099AE000INSTALLER & REMOVER
ST-A
ST-B
RS-00052
RS-00083