Subaru LEGACY 2006 Manual page 3734

asieps_tobira.book 69 ページ ２００９年１０月２６日 月曜日 午前９時１６分
5) Install the hypoid driven gear to the differential
case using twelve bolts.
Tightening torque:
T: 62 N·m (6.3 kgf-m, 45.6 ft-lb)
(A)
(B)
(A) Hypoid driven gear
(B) Differential case
2. SIDE RETAINER
1) Install a new oil seal.
ST 18675AA000 DIFFERENTIAL SIDE OIL
SEAL INSTALLER
NOTE:
• When press-fitting the oil seal to the retainer, tap
with a plastic hammer etc. to press in.
• Never use a press.
2) Install a new O-ring.
NOTE:
Do not stretch or damage the O-ring.
Front Differential Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL
E: INSPECTION
Repair or replace the differential gear in the follow-
ing cases:
• When the hypoid drive gear and drive pinion
shaft tooth surfaces are damaged, excessively
worn, or seized.
• When the roller bearing on the drive pinion shaft
is worn or damaged.
• When there is damage, wear or seizure of the dif-
ferential bevel pinion, differential bevel gear, wash-
er, pinion shaft or straight pin.
• When the differential case has worn or damaged
sliding surfaces.
T
MT-00993
(H)
ST
MT-00289
MT-00279
5MT-69
(A)
(E)
(F)
(C)
(B)
(G)
(D)
(I)
(H)
(A) Drive pinion shaft
(B) Hypoid driven gear
(C) Pinion shaft
(D) Straight pin
(E) Washer
(F) Differential bevel gear
(G) Differential bevel pinion
(H) Roller bearing
(I) Differential case
(G)
(F)
(E)
MT-00291