Subaru LEGACY 2006 Manual page 4055

asieps_tobira.book 17 ページ ２００９年１０月２６日 月曜日 午前９時１６分
4. Tilt Steering Column
A: REMOVAL
(1) Tilt steering column
1) Remove the steering wheel. <Ref. to PS-14, RE-
MOVAL, Steering Wheel.>
2) Remove the universal joint. <Ref. to PS-15, RE-
MOVAL, Universal Joint.>
3) Remove the instrument panel lower cover under.
4) Remove the instrument panel lower cover upper.
5) Remove all connectors from the steering col-
umn.
6) Remove the two bolts under instrument panel
securing the steering column.
Tilt Steering Column
(2)
(2) Universal joint
PS-00444
PS-17
POWER ASSISTED SYSTEM (POWER STEERING)
(1)
7) Pull out the steering shaft assembly from the
hole on toe board.
CAUTION:
• Be sure to remove the universal joint before
removing steering shaft assembly installing
bolts when removing steering shaft assembly
or when lowering it for servicing other parts.
• Do not loosen the tilt lever when the steering
column is not secured to the vehicle.
B: INSTALLATION
1) Install the grommet to the toe board.
2) Insert the end of the steering shaft into the toe
board grommet.
PS-00768
PS-00041