Subaru LEGACY 2006 Manual page 3687

asieps_tobira.book 10 ページ ２００９年１０月２６日 月曜日 午前９時１６分
CONTROL SYSTEMS
D: INSPECTION
1. SHIFT LOCK OPERATION
Step
1 CHECK SHIFT LOCK.
1) Turn the ignition switch to ON.
2) Shift the select lever to shift to the "P"
range.
2 CHECK SHIFT LOCK.
3 CHECK KEY INTERLOCK.
4 CHECK BACKUP POWER SUPPLY CIR-
CUIT.
Inspect the backup power supply circuit.
<Ref. to CS-11, BODY INTEGRATED UNIT
POWER SUPPLY AND GROUND CIRCUIT,
INSPECTION, AT Shift Lock Control System.>
5 CHECK KEY INTERLOCK.
AT Shift Lock Control System
Check
While brake pedal is not
depressed, is it possible to
move the select lever from the
"P" range to other ranges?
While brake pedal is
depressed, is it possible to
move the select lever from the
"P" range to other ranges?
When the select lever is set to
other than "P" range, can the
ignition switch turned to the
"LOCK" position?
Is the backup power supply cir-
cuit operating properly?
When the select lever is in the
"P" range, can the ignition
switch be turned to the "LOCK"
position?
CS-10
Yes No
Inspect "SELECT Go to step 2.
LEVER CANNOT
BE SHIFT
LOCKED". <Ref.
to CS-12, SELECT
LEVER CANNOT
BE SHIFTED,
INSPECTION, AT
Shift Lock Control
System.>
Go to step 3. Inspect "SELECT
LEVER SHIFT
LOCK CANNOT
BE RELEASED".
<Ref. to CS-14,
SHIFT LOCK OF
SELECT LEVER
CANNOT BE
RELEASED,
INSPECTION, AT
Shift Lock Control
System.>
Go to step 4. Go to step 5.
Perform the Repair the backup
inspection of "KEY power supply cir-
INTERLOCK cuit.
DOES NOT BE
LOCKED OR
RELEASED".
<Ref. to CS-14,
SHIFT LOCK OF
SELECT LEVER
CANNOT BE
RELEASED,
INSPECTION, AT
Shift Lock Control
System.>
AT shift lock sys- Perform the
tem is normal. inspection of "KEY
INTERLOCK
DOES NOT BE
LOCKED OR
RELEASED".
<Ref. to CS-14,
SHIFT LOCK OF
SELECT LEVER
CANNOT BE
RELEASED,
INSPECTION, AT
Shift Lock Control
System.>