Subaru LEGACY 2006 Manual page 4016

asieps_tobira.book 46 ページ ２００９年１０月２６日 月曜日 午前９時１６分
POWER ASSISTED SYSTEM (POWER STEERING)
10) Disassemble the oil pump and bracket by in-
serting a flat tip screwdriver as shown in the figure.
2. H6 MODEL
1) Disconnect the ground cable from battery.
2) Remove the cover of the pulley belt.
3) Remove the V-belts.
4) Remove the power steering pressure switch
connector.
5) *Remove the tensioner adjuster.
6) Disconnect the pressure hose and suction hose
from the oil pump.
CAUTION:
• Do not allow fluid to flow from the hose end
and contact the pulley belt
• To prevent foreign objects from entering the
hose, cover the hose openings with a clean
cloth.
(1)
(2)
(1) Suction hose
(2) Pressure hose
7) Remove the bolts which holds the power steer-
ing pump bracket.
Oil Pump
8) Place the oil pump bracket in a vise, and remove
the two bolts from the front side of the oil pump.
CAUTION:
When securing the oil pump bracket in a vice,
hold the oil pump bracket with the least possi-
ble force between two pieces of wood.
PS-00129
9) Remove the bolt from the back side of the oil
pump.
10) Remove the oil pump from the bracket.
PS-00700
PS-00701
PS-46
PS-00229
PS-00702