Subaru LEGACY 2006 Manual page 3249

asieps_tobira.book 94 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
• Heel contact (outside end contact)
Check item: Teeth contact area is too small.
Contact pattern
Corrective action: Increase thickness of pinion
height adjusting washer according to the proce-
dures for moving the drive pinion closer to the driv-
en gear.
6) If tooth contact is correct, mark the retainer posi-
tion and loosen it. After fitting a new O-ring and oil
seal, screw in the retainer to the marked position.
Tighten the lock plate with specified torque.
Tightening torque:
25 N·m (2.5 kgf-m, 18 ft-lb)
(A)
(A) Lock plate
Drive Pinion Shaft Assembly
AT-00211
AT-00212
AT-00214
4AT-94