Subaru LEGACY 2006 Manual page 3410

asieps_tobira.book 14 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
6. Subaru Select Monitor
A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
(DTC)
1) Prepare the Subaru Select Monitor kit.
2) Connect the diagnosis cable to the Subaru Se-
lect Monitor.
3) Insert the cartridge to the Subaru Select Monitor.
<Ref. to 4AT(diag)-6, PREPARATION TOOL, Gen-
eral Description.>
4) Connect the Subaru Select Monitor to the data
link connector.
(1) Data link connector is located in the lower
portion of instrument panel (on the driver's
side).
(1)
(1) Data link connector
Subaru Select Monitor
(2) Connect the diagnosis cable to the data link
connector.
NOTE:
Do not connect scan tools except for Subaru Select
Monitor or OBD-II general scan tool.
5) Turn the ignition switch to ON (engine OFF) and
Subaru Select Monitor switch ON.
AT-00338
(A) Power switch
6) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
7) On the «System Selection Menu» display
screen, select the {Transmission} and press the
[YES] key.
8) Press the [YES] key after the information of
transmission type is displayed.
9) On the «Transmission Diagnosis» screen, select
{DTC Display}, and then press the [YES] key.
NOTE:
• For details concerning the operation procedure,
refer to the "SUBARU SELECT MONITOR OPER-
AT-00339
ATION MANUAL".
• For details concerning DTC, refer to "List of Diag-
nostic Trouble Code (DTC)".<Ref. to 4AT(diag)-27,
List of Diagnostic Trouble Code (DTC).>
ABS00465
4AT(diag)-14
(A)
AT-00341