Subaru LEGACY 2006 Manual page 3333

asieps_tobira.book 33 ページ ２００９年１０月２６日 月曜日 午前９時１６分
8. Transfer Clutch Pressure
Test
A: INSPECTION
1) Lift-up the vehicle.
2) Remove the bolts holding the heat shield cover,
and move the heat shield cover to the rear.
3) Remove the test plug and install the ST.
CAUTION:
Be careful not to cut yourself on the heat shield
cover when removing the test plugs and setting
the ST.
ST 498897700 OIL PRESSURE ADAPTER
ST 498897800 ADAPTER SET
Range of the Throttle valve
selector lever angle
Full open
D
Partial throttle
N Full closed
Transfer Clutch Pressure Test
4) Set the ST.
ST 498575400
5) Lower the vehicle, and pull ST3 into the vehicle.
ST1 498897700
ST2 498897800
ST3 498575400
6) Connect the Subaru Select Monitor to the data
link connector and read the current data. <Ref. to
5AT(diag)-16, READ CURRENT DATA, OPERA-
TION, Subaru Select Monitor.>
7) Perform the transfer clutch pressure test.
NOTE:
• Do not perform the transfer clutch pressure test
for more than 5 seconds at a time. Doing so will
make the engine oil and ATF deteriorate and the
clutch and brake to be adversely affected.
• After performing the transfer clutch pressure test,
be sure to cool down the engine for at least one
minute with the select lever set in the "P" or "N"
range, and at an idle speed of 1,200 rpm or less.
• Adjust the throttle valve angle in order to obtain
the "T/F solenoid target pressure" displayed on the
Subaru Select Monitor.
AT-03275
8) Remove the ST and install the test plug.
Tightening torque:
13 N·m (1.3 kgf-m, 9.6 ft-lb)
9) Install the heat shield cover.
"T/F Solenoid Target Pressure" dis-
ATF tempera-
played on the Subaru Select Monitor
ture condition
45 — 55°C
(113 — 131°F)
5AT-33
AUTOMATIC TRANSMISSION
OIL PRESSURE GAUGE
ASSY
OIL PRESSURE ADAPTER
ADAPTER SET
OIL PRESSURE GAUGE
ASSY
Standard line pressure
kPa (kg/cm
kPa
800 — 915
900
(8.16 — 9.33, 116.0 — 132.7)
400 — 535
500
(4.08 — 5.46, 58.0 — 77.6)
0
(0 — 0.51, 0 — 7.3)
2
, psi)
0 — 50