Subaru LEGACY 2006 Manual page 4071

asieps_tobira.book 7 ページ ２００９年１０月２６日 月曜日 午前９時１６分
B: INSTALLATION
CAUTION:
Be sure the lining surface is free from oil and
grease.
1) Apply brake grease to the following locations.
Brake grease:
Brake Grease (Part No. 003602002)
• Six contact surfaces of the shoe rim and back
plate packing
• Contact surface of the shoe wave and the anchor
pin
• Contact surface of the lever and strut
• Contact surface of the shoe wave and the adjust-
er assembly
• Contact surface of the shoe wave and the strut
• Contact surface of the lever and the shoe wave
2) Insert the primary side brake shoe into the an-
chor pin groove.
3) Secure the brake shoe with the shoe hold-down
pin and cup.
4) Install the plate to the anchor pin, then install the
primary return spring.
(1)
(4)
(5)
(1) Primary return spring
(2) Anchor pin
(3) Plate
(4) Primary shoe
(5) Shoe hold-down pin and shoe hold-down cup
5) Install the parking brake cable to the lever.
Parking Brake Assembly (Rear Disc Brake)
(2)
(3)
PB-00039
PB-7
6) Install the strut and adjuster, then secure the
secondary side brake shoe with the shoe hold-
down pin and cup.
NOTE:
• Install the strut spring of both right and left wheel
facing vehicle front.
• Install the adjuster assembly with screw section
on the left side.
(1) LH
7) Install the secondary return spring and the ad-
justing spring.
(1)
(2)
(8)
(1) Lever
(2) Secondary brake shoe
(3) Strut spring
(4) Strut
(5) Return spring
(6) Adjuster
(7) Shoe hold-down cup
(8) Adjusting spring
8) Adjust the parking brake. <Ref. to PB-8, AD-
JUSTMENT, Parking Brake Assembly (Rear Disc
Brake).>
PARKING BRAKE
PB-00016
(4)
(3)
(5)
(7)
(6)
PB-00076