asieps_tobira.book 28 ページ 2009年10月26日 月曜日 午前9時16分
CLUTCH SYSTEM
C: INSPECTION
1) Make sure that engine does not start with clutch
pedal not depressed. If the engine starts, adjust the
clutch switch and inspect the starter interlock cir-
cuit.
2) Make sure that engine starts with clutch pedal
fully depressed. If the engine does not start, adjust
the clutch switch and inspect the starter interlock
circuit.
3) Check the clutch switch for continuity. If the re-
sistance is not at the standard value, replace the
switch.
(1) Disconnect the clutch switch connector.
(2) Measure the resistance between terminal 1
and 2 of the switch.
Condition
When clutch pedal is
depressed
When the clutch pedal
is depressed.
Clutch switch (Clutch start)
Clutch switch (Cruise control)
Clutch Switch
Specified resis-
Terminal No.
tance
Less than 1 Ω
1 and 2
1 and 2
1 MΩ or more
1
2
CL-00102
2 1
CL-00084
CL-28
D: ADJUSTMENT
1) Loosen the lock nut of clutch switch (clutch
start).
(A)
(A) Lock nut
(B) Clutch switch (Clutch start)
2) Fully depress the clutch and hold it.
3) Adjust the gap of the clutch pedal plate and the
clutch switch to be 2 — 2.5 mm (0.08 — 0.10 in).
(A)
(C)
(A) Plate
(B) Clutch switch (Clutch start)
(C) 2 — 2.5 mm (0.08 — 0.10 in)
4) Tighten the lock nut.
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
(B)
CL-00105
(B)
CL-00104