Subaru LEGACY 2006 Manual page 3700

asieps_tobira.book 28 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AT Steering Shift Switch
CONTROL SYSTEMS
5. AT Steering Shift Switch
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Set the tire to the straight-ahead position.
3) Remove the airbag module. <Ref. to AB-17, RE-
MOVAL, Driver's Airbag Module.>
WARNING:
If airbag modules are mounted, always refer to
"Airbag System" when performing airbag mod-
ule service. <Ref. to AB-17, INSPECTION, Driv-
er's Airbag Module.>
4) Remove the steering wheel. <Ref. to PS-14, RE-
MOVAL, Steering Wheel.>
5) Remove the cover from steering wheel.
6) Remove the AT steering shift switch mounting
screws from the left and right side, one on each
side.
CS-00331
7) Remove the steering shift switch.
B: INSTALLATION
1) Clean all parts before installation.
2) Install in the reverse order of removal.
3) After completing installation, set the select lever
to the SPORT shift side and confirm that manual
mode "1" illuminates on the combination meter.
4) Operate the steering shift switch and confirm
that "2" illuminates on the combination meter.
CS-28