Subaru LEGACY 2006 Manual page 3393

asieps_tobira.book 41 ページ ２００９年１０月２６日 月曜日 午前９時１６分
36) Install the intercooler stay RH and engine
hanger rear. (Turbo model)
37) Install the engine hanger rear, and then con-
nect the engine harness connector. (Non-turbo
model)
(A)
(A)
(A) Engine harness connectors
(B) Engine hanger rear
38) Install the water by-pass pipe. (Turbo model)
39) Pour ATF from the oil charge pipe. <Ref. to
5AT-26, REPLACEMENT, Automatic Transmis-
sion Fluid.>
40) Install the air breather hose. <Ref. to 5AT-61,
INSTALLATION, Air Breather Hose.>
41) Install the intercooler. (Turbo model)<Ref. to
IN(H4DOTC)-12, INSTALLATION, Intercooler.>
42) Install the air intake chamber. (Non-turbo mod-
el) <Ref. to IN(H6DO)-7, INSTALLATION, Air In-
take Chamber.>
43) Install the air cleaner case. (Non-turbo model)
<Ref. to IN(H6DO)-6, INSTALLATION, Air Cleaner
Case.>
Automatic Transmission Assembly
44) Install the collector cover.
45) Connect the ground cable to battery.
46) Perform Clear Memory 2 operation. <Ref. to
5AT(diag)-18, CLEAR MEMORY MODE, OPERA-
TION, Subaru Select Monitor.>
AT-01365
(B)
47) Perform the inspection with driving the vehicle
at the end of repair work, and make sure there is no
faulty as below;
• Excessive shift shock
• Oil leakage from the transmission body, etc.
AT-02023
• Occurrence of noise caused by interference etc.
NOTE:
If excessive shift shock is felt, execute advance op-
eration of learning control. <Ref. to 5AT(diag)-22,
PROCEDURE, Learning Control.>
AT-01366
5AT-41
AUTOMATIC TRANSMISSION
(1) Connect the Subaru Select Monitor to the
data link connector.
(2) Turn the ignition switch to ON (engine OFF)
and turn Subaru Select Monitor switch to ON.
(3) Ensure that the select lever is in the "P"
range.
(4) On the «Main Menu» display screen, select
the {Each System Check} and press the [YES]
key.
(5) On the «System Selection Menu» display
screen, select the {Transmission} and press the
[YES] key.
(6) Press the [YES] key after the information of
transmission type is displayed.
(7) On the «Transmission Diagnosis» display
screen, select the {Clear Memory 2} and press
the [YES] key.