Subaru LEGACY 2006 Manual page 3282

asieps_tobira.book 38 ページ ２００９年１０月２６日 月曜日 午前９時１６分
AUTOMATIC TRANSMISSION
B: INSTALLATION
1) Replace the differential side oil seal with a new
part.
NOTE:
When a new oil seal has been installed, replace-
ment is not required.
2) Install the rear cushion rubber to the transmis-
sion assembly.
Tightening torque:
40 N·m (4.1 kgf-m, 30 ft-lb)
3) Attach the ST to the converter case.
ST 498277200 STOPPER SET
4) Install the transmission onto the engine.
(1) Lift-up the transmission gradually using
transmission jack.
(2) Engage at the spline section.
(3) While raising the transmission jack gradual-
ly, turn the screw of engine support, and then tilt
the engine forward.
Automatic Transmission Assembly
5) Install the transmission rear crossmember.
Tightening torque:
6) Remove the transmission jack.
7) Tighten the bolts which hold the lower side of the
transmission to the engine.
Tightening torque:
ST
AT-00103
8) Install the clutch housing cover bolts.
9) Lower the lift.
10) Connect the engine and transmission.
NOTE:
AT-00109
When removing the ST, be careful not to drop it into
converter case.
ST 498277200
4AT-38
T1: 35 N·m (3.6 kgf-m, 26 ft-lb)
T2: 75 N·m (7.6 kgf-m, 55 ft-lb)
T2
T1
50 N·m (5.1 kgf-m, 36.9 ft-lb)
(1) Remove the ST from converter case.
STOPPER SET
(2) Install the starter.
<Ref. to SC(H4SO)-6, INSTALLATION, Start-
er.>
T2
AT-01335
AT-00108