Subaru LEGACY 2006 Manual page 4166

asieps_tobira.book 14 ページ ２００９年１０月２６日 月曜日 午前９時１６分
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS)
Content
Power supply
Front LH wheel
Front RH wheel
ABS wheel speed
sensor
Rear LH wheel
Rear RH wheel
Output (Lateral G sensor)
Power supply
Output (Yaw rate sensor)
Yaw rate & lateral
Standard (Yaw rate sensor)
G sensor
Test
Ground
CAN communication line (+)
CAN communication line (–)
Valve relay power supply
Motor relay power supply
Power supply
Pressure sensor Output voltage
Ground
ABS warning light
Brake warning light (EBD warning light)
Stop light switch
Subaru Select Monitor
Vehicle speed output signal
Ground
Control Module I/O Signal
Terminal No.
(+) — (–)
14 — 6
Power supply 41 — 6
Signal 25
Power supply 22 — 6
Signal 21
Power supply 24 — 6
Signal 40
Power supply 23 — 6
Signal 38
3 — 16 When the vehicle is on level surface, 2.35 — 2.65 V,
30 — 16
Waveform <Ref. to VDC(diag)-16, WAVEFORM, MEA-
28 — 16
1 — 16
5 — 1 V cycle for 40 ms pulse signal. <Ref. to VDC(diag)-
2 — 16 16, WAVEFORM, MEASUREMENT, Control Module I/O
16
13
29
5 — 6
9 — 10
27 — 12
11 — 12
12
After turning the ignition switch to ON, 10 — 15 V during
35 — 6
After turning the ignition switch to ON, 10 — 15 V during
20 — 6
Less than 1.5 V when the stop light is OFF; otherwise, 10
37 — 6
26 — 6
36
6
VDC(diag)-14
Input/Output signal
Measured value and measuring conditions
10 — 15 V when the ignition switch is ON.
4.5 — 16.5 V
5.9 — 16.8 mA: Rectangle waveform
4.5 — 16.5 V
5.9 — 16.8 mA: Rectangle waveform
4.5 — 16.5 V
5.9 — 16.8 mA: Rectangle waveform
4.5 — 16.5 V
5.9 — 16.8 mA: Rectangle waveform
8 — 16 V when the ignition switch is ON.
SUREMENT, Control Module I/O Signal.>
2.1 — 2.9 V
Signal.>
—
2.5 — 1.5 V pulse signal
3.5 — 2.5 V pulse signal
10 — 15 V when the ignition switch is ON.
10 — 15 V when the ignition switch is ON.
4.75 — 5.25 V when the ignition switch is ON.
0.48 — 0.72 V (when releasing the brake pedal)
—
1.5 seconds and less than 1.5 V after 1.5 seconds
passed.
1.5 seconds and less than 1.5 V after 1.5 seconds
passed.
— 15 V when the stop light is ON.
0 ←→ 12 V pulse (in communication)
0 ←→ 5 V pulse
—