Subaru LEGACY 2006 Manual page 3857

asieps_tobira.book 74 ページ ２００９年１０月２６日 月曜日 午前９時１６分
DIFFERENTIALS
6. Rear Differential Front Oil
Seal
A: INSPECTION
Make sure that there is no leakage from front oil
seal portion. If there is any leakage replace the oil
seal and inspect the propeller shaft.
B: REPLACEMENT
1) Shift the select lever or gear shift lever to neutral.
2) Release the parking brake.
3) Remove the oil drain plug, and drain gear oil.
• Except for VA2-type
(B)
(A) Filler plug
(B) Drain plug
• VA2-type
(B)
(A) Filler plug
(B) Drain plug
Rear Differential Front Oil Seal
(A)
DI-00356
(A)
DI-00357
DI-74
4) Install the oil drain plug.
NOTE:
• Apply liquid gasket to the oil drain plug for T-type.
• Use a new aluminum gasket for VA1-type.
• Use a new metal gasket for VA2-type.
Liquid gasket:
THREE BOND 1105 (Part No. 004403010) or
equivalent
Tightening torque:
T-type:
49 N·m (5.0 kgf-m, 36.2 ft-lb)
VA1-type:
34 N·m (3.5 kgf-m, 25.1 ft-lb)
VA2-type:
29 N·m (3.0 kgf-m, 21.4 ft-lb)
5) Jack-up the rear wheel and support the body
with rigid racks.
6) Remove the rear exhaust pipe and muffler.
7) Remove the heat shield cover. (When equipped)
8) Remove the propeller shaft. <Ref. to DS-10, RE-
MOVAL, Propeller Shaft.>
9) Remove the self-locking nut while holding the
companion flange with ST.
ST 498427200 FLANGE WRENCH
ST
10) Extract the companion flange using ST.
ST 399703600 PULLER ASSY
ST
DI-00194
DI-00196