Subaru LEGACY 2006 Manual page 4041

asieps_tobira.book 37 ページ ２００９年１０月２６日 月曜日 午前９時１６分
6. OIL LEAKAGE
e
(1) Power cylinder
(2) Cylinder
1) Lift-up the vehicle.
2) If a fluid leak is found, clean the fluid completely
from the suspect area, and turn the steering wheel
30 to 40 times to the left and right from lock to lock,
with the engine running, and check again for leaks
immediately, and also after a few hours have
passed.
3) Cause and solution for oil leakage from "a"
The oil seal is damaged. Replace the valve assem-
bly with a new part.
4) Cause and measure for oil leakage from "b".
The torsion bar O-ring is damaged. Replace the
valve assembly with a new part.
5) Cause and measure for oil leakage from "c".
The oil seal is damaged. Replace the valve assem-
bly or oil seal with a new part.
6) Cause and solution for oil leakage from "d".
The pipe is damaged. Replace the faulty pipe or O-
ring.
7) Cause and solution for oil leakage from "g".
The hose is damaged. Replace the hose with a
new part.
Steering Gearbox
POWER ASSISTED SYSTEM (POWER STEERING)
(1)
(4) (3) (2)
g
g
d
(3) Rack piston
(4) Rack axle
8) If leak is other than a, b, c, d or g, or if oil is leak-
ing from gearbox, move the right and left boots to-
ward tie-rod end side, respectively, with the
gearbox mounted to the vehicle, and remove fluid
from surrounding portions. Then, turn the steering
wheel from lock to lock about thirty to forty times
with the engine running, and make comparison of
the leaked portion immediately after and several
hours after this operation.
(1) Leakage from "e"
The cylinder seal is damaged. Replace the rack
bushing with a new part.
(2) Leakage from "f"
There are two possible causes. Perform the fol-
lowing step first. Remove the pipe assembly B
from the valve housing, and close the circuit us-
ing ST.
ST 926420000
Turn the steering wheel from lock to lock ap-
prox. 30 to 40 times with the engine running,
then inspect the leaked portion immediately af-
ter and several hours after this operation.
• If leakage from "f" is noted again:
The oil seal of pinion and valve assembly is dam-
aged. Replace the pinion & valve assembly with a
new part. Or replace the oil seal and the parts that
are damaged during disassembly with new parts.
• If oil stops leaking from "f":
The oil seal of rack housing is damaged. Replace
the oil seal and parts that are damaged during dis-
assembly with new parts.
PS-37
b
a (5)
(6)
d
c
f
(5) Input shaft
(6) Valve housing
PLUG
PS-00622